Thermotransfer technologies

HS - hot split

    Transfer temperature - 200 C, time - 5 - 8 sec strong compression of the press. About 7 atmospheres for automatic presses. The bearer has to be removed immediately after the press has been opened.

PF - puff

    Transfer temperature - 200 - 202 C, time - 3 - 5 sec strong compression of the press. 7-8 atmospheres for automatic presses. The bearer has to be removed immediately after the press has been opened ( If the lower panel of the press is too hard it is recommended to use wadded material for a better effect at the inflation ).

PSPF - process color puff

    Transfer temperature - 200 - 202 C, time - 3 - 5 sec strong compression of the press. 7-8 atmospheres for automatic presses. The bearer has to be removed immediately after the press has been opened (If the lower panel of the press is too hard it is recommended to use wadded material for a better effect at the inflation ).

CP - cold peel

    Transfer temperature 180 - 190 C, time - 10 -15 sec normal compression of the press . About 6 atmospheres for automatic presses. The bearer has to be removed at least 15 sec after the press has been opened.

GL - glitter

    Transfer temperature 190 - 200 C, time - 7 - 10 sec normal compression of the press. About 6 atmospheres for automatic presses. The bearer has to be removed at least 15 sec after the press has been opened.

GLH - hot glitter

    Transfer temperature - 200 C, time - 8 - 10 sec normal compression of the press. About 6 atmospheres for automatic presses. The bearer has to be removed immediately after the press has been opened.

    Because of the specificity of the different presses the indications above are relative. Taking this in account, always before long series you have to test, so you can tune up your press.